IKEA OV32 Manuale Utente Scaricare il pdf (Pagina 25)

4. Remove the water from the steam

generator with the sponge and rub it

dry.

5. Keep the door open to let the appliance

dry fully.

Removing and installing the door

The oven door has three glass panels.You

can remove the oven door and the internal

glass panels to clean them.

The oven door can close if you

try to remove the glass panels

before you remove the oven

door.

Caution! Do not use the

appliance without the glass

panels.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3. Close the oven door to the first opening

position (approximately 70° angle).

4. Hold the door with one hand on each

side and pull it away from the appliance

at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface. This

is to prevent scratches.

6. Hold the door trim on the top edge of

the door at the two sides and push

inwards to release the clip seal.

7. Pull the door trim to the front to remove

it.

8. Hold the door glass panels on their top

edge one by one and pull them up out

of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, install the

glass panels and the oven door. Do the

above steps in the opposite sequence.

Make sure that you put the glass panels (A

and B) back in the correct sequence. The

first panel (A) has a decorative frame. The

screen-printing zone must face the inner

side of the door. Make sure that after the

installation the surface of the glass panel

frame (A) on the screen-printing zones is

not rough when you touch it.

ENGLISH

25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

Commenti su questo manuale

Nessun commento